![]() ![]() Baseline Processing and Single Point Positioning is possible.If the user selects the manual mode, he can configure how the data is computed.Selection of Observations (supported by the graphical Selection Mechanism) and selection of GPS processing Parameters.The GPS Processing consists of two major parts.The GPS Processing may be accessed via the GPS –proc Tab within a project.Observations collected at two stations, at the same time, and to the same satellites are combined during processing.Baseline processing implies the computation of a 3-dimensional vector between two occupied sites.Average (created automatically when more than 1 measuered triplet available) īaseline Vector A B Leica Geo Office What is baseline Processing?.Leica Geo Office Point Classes The following coordinate classes are available An Interval represents the occupation of a point with GPS instrument.To view the properties->right click on a point in GPS Proc tabbed view.You can re-assign an interval to a new or existing Point EID.Deleting an Interval will automatically remove the measured triplet, the observation and as well the GPS raw data from the project.When importing GPS data a point triplet Navigated or Measured is connected to each interval (depending if it is RTK or raw data).Leica Geo Office – GNSS ProcessingContents
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |